Concrete Anchoring

Titen HD® is made from Type 316 Stainless Steel with carbon-steel lead-threads Perfect for concrete and masonry where corrosion is a concern. Serrated carbon-steel threads at the tip cut concrete and allow remaining threads to interlock with the concrete. Contains less than 1% carbon steel to minimize expansion compared to 18% found in other stainless screw anchors. Unlike other anchors, the Titen HD® will not cause concrete failure due to rust. See design info PDF in the specs section below. Install by hand or with an impact wrench. See PDF in spec section for installation information

Read more less

Type 410 Stainless Steel for enhanced corrosion protectionAvailable in Hex and Phillips Flat Head, 100pc BoxIdeal for attaching components like light fixtures or electrical boxes to concrete and masonryGreat for concrete, brick, grout-filled CMU and hollow-block applicationsSuitable for some preservative-treaded wood applicationsDrill Bits included in each box

Read more less

The Titen HD® now with countersunk head style!This high-strength screw anchor is perfect for use in cracked and uncracked concrete as well as masonry. Conveniently sold by the piece! Type 316 Stainless Steel provides long-lasting corrosion resistance. Cracked concrete code listed Provides industry leading Countersunk head leaves a flush-mount profile and clean surface appearance for exposed through-set applications performance even in seismic and wind loading conditions Installs using a standard-sized ANSI tolerance drill bit - The 3/8" Titen takes a T-50 bit, sold separately here. Removable. Great for temporary anchoring See spec table for installation pdf

Read more less

Type 316 Stainless Steel for ultimate corrosion resistance Code listed for cracked concrete and uncracked concrete See code listings Head stamped with length identification number Chamfered top to prevent mushrooming during installation Optimal choice for performance under seismic and high-wind conditions Qualified for a minimum 3-1/4” concrete thickness Tested per ACI355.2 and AC193 specifications concrete design information available in spec section below

Read more less

The WEDGE-ALL® wedge anchors are a non-bottom bearing, wedge style expansion anchor for use in solid concrete or grout filled masonry.One-piece, wrap-around clip ensures uniform holding capacityThreaded end is chamfered for ease of starting nutOne piece wrap around clipSupplied with a nut and washerThreaded end is chamfered for ease of starting nutThreaded studs are set by tightening the nut Discontinued product, limited quantities available

Read more less